Remote cable for aftermarket amplifier


  • @gustavo montemayor 

    Hello.
    Could you pleaes check whether it works well if you turn on the headlight?

     


  • @Support Dasaita Qiero tambien  mencionar  que  ene  ocasiones  se  deja  de escuchar  la musica   de  spootify o playmusic  son intermitencias   en ocasiones  y algunas veces  se  desconecta el  carplay  y se  vueleve  a conectar  ya  slo  use   con 2  telefonos  diferentes  y es lo mismo   sera que   se debe  actulizar   la  aplicacion   ZTE    gracias 


  • @gustavo montemayor 

    Hello.

    About CarPlay issue, please try to do as follows:
    1. Re-pair your phone's Bluetooth with the head unit.
    2. Enable CarPlay on your head unit.
    3. On your phone, turn on Wi-Fi and search for your head unit's hotspot (e.g., "Android-***") to connect.
    4. Go back to the CarPlay interface, it should connect automatically.

    To further confirm, please go Settings > About Machine, 
    then provide the following picture: Build Number; MCU version.


  • hola  nuevamente  estoy teniendo problemas  ya que de  repente  se  desconecta    de car play y despues  d e 1 min aprox  se vuelve  a conectar solo   y en ocasiones   no se  desconecta pero  se deja  de escuchar  la musica y despues de 2  segundos    se  escucha   



  • hola  tendras una aplicacion de  radio  am/fm  diferente a  la que viene  de  inicio  ya que  no es muy amigable   y se batalla  para    buscar  poder  sintonizar  una estacion dura  solo 3 segundos y se  cambia  ya puse  en varias opciones y no     seria mejor  una  APK   de  radio  diferente  grcias 


  • @gustavo montemayor

    Entendemos perfectamente que la aplicación de radio predeterminada pueda resultar incómoda al buscar o sintonizar emisoras. La buena noticia es que tiene fácil solución y solo lleva unos segundos:
    Simplemente ve a Google Play Store e instala la aplicación de radio de terceros que prefieras.

    Cabe aclarar que, por el momento, el dispositivo solo incluye la aplicación de radio predeterminada preinstalada. Además, la radio satelital XM funciona perfectamente a través de CarPlay.

    Si tienes algún problema durante la instalación o el uso, no dudes en contactarnos.


  • Hello everyone,

    I’m having an issue with the RCA audio outputs on my Desaita G13 installed in a 2023 Toyota Tacoma (non-JBL).

    I installed a Kicker Hideaway HS10 powered subwoofer, but I get no audio signal from the head unit.

    Here is everything I have already tested:

    •⁠  ⁠Vehicle: 2023 Toyota Tacoma, non-JBL factory audio.
    •⁠  ⁠Head unit: Desaita G13.
    •⁠  ⁠Subwoofer: Brand new Kicker Hideaway HS10.
    •⁠  ⁠The amplifier powers on normally (green LED is on).
    •⁠  ⁠I previously had a Nakamichi powered subwoofer, and it had exactly the same issue (no sound).
    •⁠  ⁠I have tested both the SUB OUT RCA and the FRONT OUT RCA from the Desaita harness.
    •⁠  ⁠I adjusted all DSP/amplifier settings, including Subwoofer ON, subwoofer level, crossover, and amplifier settings.
    •⁠  ⁠I verified the Kicker is configured for LOW LEVEL (RCA) input.
    •⁠  ⁠I am using the original RCA harness supplied with the Desaita.
    •⁠  ⁠Despite all of this, there is still no audio signal from any RCA output.

    Has anyone experienced this with a G13?

    Could this be:

    •⁠  ⁠a defective RCA harness,
    •⁠  ⁠a faulty RCA output on the head unit,
    •⁠  ⁠or is there another setting that enables the RCA outputs?

    Any suggestions would be greatly appreciated.

    Thank you!


  • hola  me pasa que  el car play  se desconecta de mi  iphone     siempre  en 3  ubicacion es  que suelo pasar   lo valide  mas de 5 veces   ya que  es mi trayecto diario  , paso  esa zona    y metros mas  adelente  se vuelve a conecatr


  • ES   LA VERSION ACTUAL TENDRAS  UNA  MAS  ACTUALIZADA  YA   QUE TAMBIEN   EL SPOOTIFY QUE BAJO  DE   PLAYSTORE  EN ANDROID  DESPUES DE 2  DIAS  SE   DESCONFIGURA  Y DEBO  INSTALAR  DE NUEVO 


  • @gustavo montemayor Hi gustavo,

    For an active subwoofer, you will need to connect to the vehicle's battery — both B+ (positive) and GND (ground). Additionally, the AMP wire (amplifier turn-on signal) should be connected to the REM (remote turn-on input) on the subwoofer


  • 1
  • 2 / 2
Please login to reply to this topic!