@Tyler Martin  For the bluetooth,please go Settings > Car > Factory setting (Password: 126) > App >BT to choose the suitable one1.FSC-BW1242.WQ RF2103.WQ-BC64.SDIO-AUTO For the Z...

@Martin Karbon  Hello, This MCU and firmwar isn't for your unit. Please find a pin, press and hold the RST button for 15 seconds to see if you can enter the factory setup page, if you can...

@Tyler Martin  For the Bluetooth，please go Settings > Car > Factory setting (Password: 126) > App >BT to try the suitable one for your unit. 1.FSC-BW1242.WQ RF2103.WQ-BC64.SD...

@osamu nonaka  Just would like to confrim is the factory camera o aftermarket camera？ If  it is factory,you don't need to connect the AUX -V cable. If it is aftermarket camera,please s...

@Philippe Marsteau  Thank you for your time an patience in this matter. We have just been informed that MCU has been stopped updating. Please keep the current version working on the unit. D...

I have the same exact problem. Just started a topic about it as well.

Everything was working fine, until this happened. I tried a factory reset, and it still does it. Is there different software i can use?

When i start the car, android auto starts and the music plays for a split second then stops....it seems like the stock bluetooth app on the unit tries to take over and stops android auto. When that...

I hav

Is this connection correct?

@Support Dasaita also the buttons don't light up but beep when touched

Hi I tried installing the Vivid11 update and MCU as described here https://www.dasaita.com/community/forum/topic/126757/tundra-vivid11-black-screen but now when I turn the stereo on the screen is...

@Jay Yeager Thank you!

@Support Dasaita OK, the screen calibration worked great! However the bluetooth is still not working. Additionally, the CarPlay app (Zlink) is missing. 

@Tyler Martin 126

What is the pin for the factory settings?

So I just need to connect the yellow Canbus plug to the output CAM VIN?

I can tune into Japanese frequencies, but I can't register them in the memory.

Pressing for 15s made the head unit start again. Since MCU never went through, it still runs same older version I had prior to attempting upgrade. any idea why the upgrade failed when applying the...

@osamu nonaka We are wondering if your connection is the same as follow but no luck to get the rear camera worked.